Reset Command for SB2

[Beno]

Welcome to the forums.!

I have not done it, but I believe that the serial brains have the same memory map space as the Ethernet ones.
You should be able to write this command to this address and have it reset.

Reset controller from software?

In OptoControl there used to be a command that would reboot the controller from software. I don’t find a command that does the same thing in PAC Control, but I did find the MMP address F038 0000 where I can write a 5 and it will supposedly do so… However, it doesn’t always seem to work even though I get a result from the write command of zero (success). Is there some other way to do this, or am I missing something? CM_MMP_Result = WriteNumToIoUnitMemMap(LocalUnit, 0xF0380000, 0x00000005); //…

If not, come back and we will dig a little deeper.

EDIT: I took a look at doc 1465, the OptoMMP protocol guide.

Here is a screenshot of the reset MMP address;