Is there a command to restart the R1 controller in a chart?

[zhhpei]

Is there a command to restart the R1 controller in a chart?

[Beno]

Did you try the forums search?

Reset controller from software?

In OptoControl there used to be a command that would reboot the controller from software. I don’t find a command that does the same thing in PAC Control, but I did find the MMP address F038 0000 where I can write a 5 and it will supposedly do so… However, it doesn’t always seem to work even though I get a result from the write command of zero (success). Is there some other way to do this, or am I missing something? CM_MMP_Result = WriteNumToIoUnitMemMap(LocalUnit, 0xF0380000, 0x00000005); //…

[zhhpei]

OptoControl ？ I’m using paccontrol 9.6 now. Can I still use it?

[Beno]

The version of Pac Control or OptoControl or IO Control or Factory Floor does not matter. MMP addresses have been there since the first version.

Yes.

[zhhpei]

Thank you very much for your help!