C++ access of EPIC serial module port

[Beno]

Hmmm. Ok.
I found where I posted about accessing the serial ports on the module directly via Linux, its here;

Using GRV-CSERI ports from a program

I found a few things out and from that have inferred the answer is ‘should be possible’. Here you can see the shell program ‘minicom’ receiving data from a GPS receiver sitting on my desk (it was the only serial device I could quickly put my hands on). [image] You can see I have set the baud rate to 9600, 8 data bits, No parity and 1 stop bit. I did this from within Minicom. Since I can do it there, I am inferring that you should be able to set the comm port parameters from the Linux progr…

Might have to revisit it from a C++ point of view (in which case, I am not the guy, but might know a guy).

EDIT. Try using /dev/ttyUSB0