Groov time on trends fixed?

[philip]

@Jonathan_Fischer

philip:

Also, if you change the timezone on a PR1, it has to be restarted before groov view will recognize it.

I think I have a fix for that in the next release. There’ll still be a delay, but it should correct itself within a minute or so.

Do you know if this ever got resolved? I looked through the firmware readme and didn’t see anything. I have an AR1 on R4.0c where the time on the trends were off by an hour after DST ended until it was restarted.

I will risk updating the firmware if this has been resolved.

[Jonathan_Fischer]

Not yet, no. I ran out of time heading into code freeze. Soon-ish though!